Sticking Awning Windows

I'd try the RV seal lubricant.

Actually they are called awning windows. Louvered windows would be a series of small windows stacked vertically that open from the bottom simultaneously. Like louvered shutters.

This is from Kolbe Windows products page.

"Awnings:

Awning windows open from the bottom out. The glass creates an awning above the opening, providing ventilation in a variety of weather conditions. Awnings’ unique style and operation create an unobstructed view with venting flexibility. Their versatility can also create architectural interest in small spaces, especially when combined with casements and picture windows."

mileshuff wrote:
On most newer Winnebago RV's they use frameless windows. The have a twist knob inside that operates a scissor mechanism to push the bottom of the window outwards. The top of the window is hinged. I have the same trouble with occasional sticking. Haven't tried but am told either a dry lube or talcum powder will work.

Mine behave the same. I just turn the crank until it puts some pressure on the window and then stop and wait. Usually in about 5 - 10 seconds the window pops free from the gasket. After that it works fine for the rest of the trip.

Gummi Pflege Stift rubber care stick.

It's water based and silicone free.

Should do the job on your sticky windows.

Regards
Kyte NW PA

Talcum powder on the seals.

On most newer Winnebago RV's they use frameless windows. The have a twist knob inside that operates a scissor mechanism to push the bottom of the window outwards. The top of the window is hinged. I have the same trouble with occasional sticking. Haven't tried but am told either a dry lube or talcum powder will work.

Good advice from navegator above. Another technical name for these types of windows, since we're into naming, is jalousie window.

Paste wax applied to the sealing surfaces of operating windows tends to eliminate a lot of sticking.

I believe they are called louver windows, and they are being used more on the high end units today, if they have a rubber seal, the rubber tends to deteriorate and stick to the glass, the same as the windshield wipers, you might try getting some of the fluid that is used to mount tires, you might be able to get some from the tire store, take a mayo jar and ask for some, put a little on a rag and wipe the seal so hat the window does not stick, this is a rubber lubricant, you can also spray it on the rubber mounts from the shocks when they start to squeak and he sway bar bushings.

On the crank mechanism buy some 3-in-1 oil and put a couple of drops on the crank and hinge at the tops.

Do not use WD-40, it tends to collect a lot of dust very fast and leaves a grey residue on the long run.

navegator

You might try "Sildeout Seal Conditioner" from CW. I would spray it on a rag and then wipe a little on the seals. Trying to spray it on the window frame would make a giant mess.

Ours stick badly too, and they are very irritating because they are hard to open anyways, then to top it off, they put the knob behind the valances.
Let me know if you figure something out that works.

Awning windows are windows that open from the bottom outward. (Casement windows crank open like a door.) I don't know if RV windows like this are called awning windows or not. My widows rest on a rubber seal and open from the bottom outward. They are not sliding windows in a track. Thanks anyway.