I know there are a lot of ways to get the bugs off of our coaches but stumbled on this one recently and thought I would share. Bought a starter kit of Bugslide at the Laughlin River Run last month to use on my motorcycle {almost as great a bug catcher as our class C}. {yes I ran the serach feature before posting and it came up empty on "Bugslide".}Just {pump} spray it on and wait about 30 seconds and then wipe the critters away. It leaves a nice sheen and actually smells pretty decent. I have been having such good results with it over the last month on my New Indian Springfield I decided to go big and tackle our 24' Class C this morning. We had just returned from a 1,300 mile, 10 day, jaunt up to Angel Fire NM and as usual after a trip the cabover was covered in bugs.Just reaching the cabover of Class C can be a challenge but after a thorough washing {think long handled soft bristle brush} the coach look pretty good... except for the bug collection on the cabover.By placing a 6' step ladder as close to the cab as possible and moving it a couple of feet every few minutes I was able to reach the entire cabover. This did entail couple of long reaches but with one foot gently resting on a towel near the windshiled and the other on the ladder it was doable. Not much rubbing involved and I even went one step further and put a great coat of wax on after the Bugslide.The wax is "Chemical Guys - Butter Wax" {Amazon} and puts a shine down like you would not believe. I have also tested this product on my motorcycle with unbelievable results. Anyway here is a pic:For the record that is our 2012 Nexus Phantom 23P with 49,800+ miles on it. I am guessing that between the Bugslide and the Butter Wax the next crop of bugs should stick less and come off even easier... film at eleven.:C

Does the use of Bugslide or the Chemical Guys-Butter Wax have any effect on the vinyl graphics? I've been looking for something to use other than dryer sheets. They work for the most part but looking at the front cap on our 5th wheel in the reflection, you can still see where the bugs splattered. I want a product that eliminates any signs of bug splatter that won't hurt the adhesive on the vinyl graphic and won't hurt the graphic itself.

Do you hold any services or memorials before or after bug removal? Where do you inture the departed?

is this the product you're using:https://www.amazon.com/Bug-Slide-trigger-Cleaner-Remover/dp/B004CMDDOC

rk911 wrote:is this the product you're using:https://www.amazon.com/Bug-Slide-trigger-Cleaner-Remover/dp/B004CMDDOCYes, as noted it works very well.I have used it on vinyl graphics and the Nexus logo on the Cabover without any issues. As I said, bought both products primarily to use on my bike but when they both worked so well I had to try them on the RV and the results have been spectacular. After putting a pretty good dent in the initial 16 oz bottle I went to Amazon today and ordered a half gallon {$63} to use to refill the 16 oz pumnp spray. I expect to be using the BS on both the bike and RV {same for the Butter Wax}. Will be doing both of our cars with the wax this weekend... amazing stuff.I have no connection to either product, just another happy consumer. As always... Opinions and YMMV.:C

Thanks Desert Captain. I just bought a bottle of each to try out. I hope I get results as good as you have!

Bugslide... it really works | Good Sam Community

garmp
Explorer II
Jun 16, 2018
Don't know about Bugslide, lighter fluid nor any other liquids but what works for us is simply. Go to the local dollar store and buy a box of fabric softener sheets. Spray the area with water and rub the sheets over the area with bugs and rinse off. A little elbow grease might be needed on suborn areas, but generally works like magic.
ktmrfs
Explorer II
Jun 13, 2018
CavemanCharlie wrote:
ktmrfs wrote:
RobWNY wrote:
rk911 wrote:
Rob, does the charcoal lighter fluid have an adverse effect on the paint?

Rk, no I have used Charcoal Lighter Fluid many times for tar removal. I just make sure I wash my vehicle good immediately after and then get a new coat of wax on it because the Charcoal Lighter Fluid strips the wax off. Any Petroleum distillate will. I would imagine if I didn't wash/wax after using it there could be an adverse effect over time. Similar to gasoline that runs down the side of a vehicle when the tank is overfilled. There's no immediate damage but long term without cleaning will cause yellowing.

similar experience. Charcoal lighter fluid is refined Naptha, an a mild solvent. Bug and tar remover is similar, in most cases Naptha and other solvents.

Naptha is a common solvent found in many many prodcuts ranging from bug removers, it's coleman stove fuel, charcoal ligher fluid, VM&P naptha is naptha foor painting thinner.

Humm, Good to know. But, at what mix level ? Pure Naptha like the types you list has a strong smell. I don't feel comfortable putting anything that strong on paint unless it has been diluted to a very low level.

I don't have my Bugs N All right in front of me but, I think is said something about no petroleum products. Not at all sure about that though.

charcoal lighter fluid is more refined and less odor than many other versions of naptha. Likely reason is to make sure it doesn't impart any taste to what you are cooking.

And I've found that off brands of charcoal lighter fluid do have more odor and some do impart a taste to the food as well.
ktmrfs
Explorer II
Jun 13, 2018
Grit dog wrote:
Naphtha won't eat your paint or gel coat. Neither will mineral spirits, gasoline, lacquer thinner, or acetone. Keep it off the stickers though!

lacquer thinner or acetone may not attack all paints, but will easily remove or damage some paints. Keep those off paint.
Grit_dog
Navigator
Jun 13, 2018
Naphtha won't eat your paint or gel coat. Neither will mineral spirits, gasoline, lacquer thinner, or acetone. Keep it off the stickers though!
CavemanCharlie
Explorer III
Jun 13, 2018
ktmrfs wrote:
RobWNY wrote:
rk911 wrote:
Rob, does the charcoal lighter fluid have an adverse effect on the paint?

Rk, no I have used Charcoal Lighter Fluid many times for tar removal. I just make sure I wash my vehicle good immediately after and then get a new coat of wax on it because the Charcoal Lighter Fluid strips the wax off. Any Petroleum distillate will. I would imagine if I didn't wash/wax after using it there could be an adverse effect over time. Similar to gasoline that runs down the side of a vehicle when the tank is overfilled. There's no immediate damage but long term without cleaning will cause yellowing.

similar experience. Charcoal lighter fluid is refined Naptha, an a mild solvent. Bug and tar remover is similar, in most cases Naptha and other solvents.

Naptha is a common solvent found in many many prodcuts ranging from bug removers, it's coleman stove fuel, charcoal ligher fluid, VM&P naptha is naptha foor painting thinner.

Humm, Good to know. But, at what mix level ? Pure Naptha like the types you list has a strong smell. I don't feel comfortable putting anything that strong on paint unless it has been diluted to a very low level.

I don't have my Bugs N All right in front of me but, I think is said something about no petroleum products. Not at all sure about that though.
ktmrfs
Explorer II
Jun 12, 2018
RobWNY wrote:
rk911 wrote:
Rob, does the charcoal lighter fluid have an adverse effect on the paint?

Rk, no I have used Charcoal Lighter Fluid many times for tar removal. I just make sure I wash my vehicle good immediately after and then get a new coat of wax on it because the Charcoal Lighter Fluid strips the wax off. Any Petroleum distillate will. I would imagine if I didn't wash/wax after using it there could be an adverse effect over time. Similar to gasoline that runs down the side of a vehicle when the tank is overfilled. There's no immediate damage but long term without cleaning will cause yellowing.

similar experience. Charcoal lighter fluid is refined Naptha, an a mild solvent. Bug and tar remover is similar, in most cases Naptha and other solvents.

Naptha is a common solvent found in many many prodcuts ranging from bug removers, it's coleman stove fuel, charcoal ligher fluid, VM&P naptha is naptha foor painting thinner.
CavemanCharlie
Explorer III
Jun 11, 2018
I've been using Bugs N All on the front of my pickup and I am very happy with it. I would never use Charcoal Lighter Fluid on anything except charcoal.

https://www.amazon.com/dp/B01AMJ5O22/ref=sxts_k2p-hero-vn-pb_bs_tr_lp_1?pf_rd_m=ATVPDKIKX0DER&pf_rd_p=6419350522255532679&pd_rd_wg=4KCe3&pf_rd_r=0XYSWK8XE4RJPW716Q2X&pf_rd_s=desktop-sx-top-slot&pf_rd_t=301&pd_rd_i=B01AMJ5O22&pd_rd_w=dA16a&pf_rd_i=bugs+n+all&pd_rd_r=aac569bb-3bbb-48ca-8770-5835a1ed27b4&ie=UTF8&qid=1528676573&sr=1
Grit_dog
Navigator
Jun 10, 2018
Desert Captain wrote:
Larry I'm not sure what your point is but I repeat if you think the only ingredients are alcohol and water you are wrong. For the record, your info is 11 years old and only relates to one ingredient... yes I am sure there is alcohol in Bugslide.

I have come acrosss a product that is giving excellent results and just wanted to share this info with others. They can elect to try it or not. If you have actually used Bugslide and had some sort of problem then please enlighten us all but no, you cannot mix water and alcohol and produce Bugslide.

:R

Haha, you've been on here long enough to know that some folks would argue that the sky is actually blue, just for the sake of argument......
Btw, your comment about common ingredients with your favorite cocktail is classic!
docsouce
Explorer II
Jun 10, 2018
My Bugslide arrived yesterday. Did the overhang today. It made quick work of the splatter I picked up on last weekend's short camping trip. Left a very nice finish too. So far so good.
We are leaving next Sunday 6/17 for New Mexico, so I'll be able to give an update on how it works on Southwest Fried Beetle innards. More info to follow.
RobWNY
Explorer
Jun 05, 2018
Desert Captain wrote:
Rob, sorry to hear you weren't happy with the Bugslide. No idea why you did not get a better result. :h I have been using it for a couple of months now with great success. I do think it gets better with multiple applications as the BS leaves a slick film behind that inhibits the next bug sticking but... when I used it on my Class C which had not been cleaned with anything but water for several months the bugs, splatter an all, came right off.

I think it is a better product than you do... you might want to give it a couple more applications and see if the results don't improve. Good luck!

Glad you liked the Butter Wax, that stuff is amazing.

:C

Captain, I know several others with motorcycles that swear by the bug slide stuff but it just wasn't good for me. I'm glad it works well for you! I will use it until the bottle is empty. No sense throwing away what I bought but I'll have my standy charcoal lighter fluid at the ready if it's needed.

Yes, the Chemical Guys Butter Wet Wax is very good. An added benefit is that you can get it on the black molding with the pebble grain without it turning white and impossible to get off.

Forum Discussion

Bugslide... it really works

About RV Tips & Tricks

Related Content

Furnace not working

Work done at dealership

Bahn Camper works

House Batteries not working?

AC not working