Can you identify this tow setup?

Google that plug and then test to see if it's wired correctly.

Is the owner supplying the missing base plate connectors? And you'll want short safety cables to the frame, the remainder is tow bar related. Does it have an aux brake or set up for Ready Brute tow bar? The jeep is heavy enough to require a aux brake in many states.

Base plate is Blue Ox, there are pieces that lock into those holes. If seller doesn't have them, you might need to buy as replacement parts, because they don't come with the tow bar, they come with the base plate.

Four-pin connector will not have lines for brake controller or charge line, four pins are the minimum for lighting needs.

My 4 round is wired to separate lights in the rear housings, and illuminates running, left and right turn and brake lights. I do not see a breakaway on the OP's photo.

Thanks very much.

That is a four round. It is for tail lights only if it was wired correctly.

Thank you for helping with both the link to the picture and the actual picture itself.

You need to see the picture to comment, Fire Up? Oh!

Well, not exactly sure just what that comment was intended to mean but, YES, I did need to see the picture, JUST LIKE EVERYONE ELSE DID so I could maybe help.
Scott

I like this


http://photoposting.is-great.net/?i=2

beaubeau wrote:
Thanks for all the help! And Scott, I have always found posting photos here to be difficult. DutchmenSport - how did you get the photo to show in your post?

Thanks for all the help! And Scott, I have always found posting photos here to be difficult. DutchmenSport - how did you get the photo to show in your post?

FIRE UP wrote:
Well,
Apparently since no one else has mentioned it, I must be the only one that cannot see the picture you're asking about. All I get is a small colored block with some italics that have "image" in the middle of them. So, so much for me trying to help.
Scott

Try this: