Did my Andersen No-Sway WDH do this???
Or did the trailer service center? I'm not sure, what caused it, but after hooking up last night I noticed chunks of aluminum on the ground under my setup. I had just got my trailer back from serv...
Forum Discussion
Housted wrote:
Look again guys there is no way that plate did that. The geometry is all wrong. Something such as a fork hit the seam just right to peel the metal like that. Look at the peeled piece it has a kink in it. How could the plate at a position below the tongue get up to that place to make the kink? Clearly the service place hit it with a fork.
Housted
Exactly! Even if the plate was/is rubbing, there is nothing on the plate to catch that weld seam on the TT and peel it back like that! If there was a notch in the plate that created a corner that could have caught on the weld, maybe. But the way it's configured, no way!
If Ben is correct about lack of weld penetration in that area, it's possible that a bump with the fork could have caused it to peel back like that.
