toilet

pushtoy 2 wrote:
i am new to this site hello all. hope someone can help me with is . i have put 3 new flush seeles in my toilet the last a little while dont understand what is happening the start leaking again the bowl stops holding water. i have put plumbers grease on it and that doesnt last eather. can anyone help.

How much is the toilet leaking? Is it leaking into the tank below, or onto the floor of the bathroom?

My toilet, which has worked the same since we bought it 18 years ago, will hold water in it for awhile but eventually it "leaks" into the tank below it. It has worked fine all these years. I do remind people to add a little water to the toilet if it is empty before they use it.

If your toilet is leaking water onto the floor of the bathroom, then you certainly do need to fix that. You may want to look into just replacing the whole toilet.

thedford low profile is all i have with me now.
sure apprecate all your time all of you are taking to help me

CavemanCharlie wrote:

Grit dog wrote:
Is it possible that there's a lip or sharp edge damaging the seals?
Any obvious damage to the old ones?

This is good advice.

Also, is it possible that you are damaging the seals when you install them ? Maybe the damage doesn't show up at first but, after awhile it causes the seal to fail ??

A little vegetable oil after instillation might help too , as someone said.

And maybe knowing make and model would get some real answers.

Grit dog wrote:
Is it possible that there's a lip or sharp edge damaging the seals?
Any obvious damage to the old ones?

This is good advice.

Also, is it possible that you are damaging the seals when you install them ? Maybe the damage doesn't show up at first but, after awhile it causes the seal to fail ??

A little vegetable oil after instillation might help too , as someone said.

thank all of you for taking the time to try an help me. i guess iam just gona have to work through this. i have had the toilet out so many times iam gettimg good at it.

enblethen wrote:
We should not suggest buying parts when we don't know make and model of the product in question!

EXACTLY!!!!!!!

This is why I asked for make and model. Funny this happens all the time.

We should not suggest buying parts when we don't know make and model of the product in question!

Try replacing the waste ball and waste ball drive. You need new drive to properly center the waste ball under the gasket. Otherwise you gotta lift it with your foot.

Have you checked your flush mechanism (foot or hand)? While our seal is fine, it's our foot flush pedal that does not spring the blade completely shut. We have to get our foot under the pedal and lift up at the end of our flushing.

Specifically what toilet are you having issues with?