wa8yxm wrote:
I put the connectors inside a plastic tool box (Notched edges and drain holes) on top of a block to get it out of pooled water, I would not wrap with palstic.
X2
Been using a plastic container with lid for years now too.
Like said connect the plugs and lay across the box and then notch the sides of the box where the wires set so they slip down below the lid but not deep enough so the sit on the bottom of the box. Drill holes in bottom and set on concrete block. Put lid on and you are good to go.
Investment? $1.00 for the plastic container at the Dollar Store! :B
