Atwood Model G6A-8E water heater fails
I have an Atwood Model G6A-8E water heater that won't run without stopping and the red light going on. What I need to know are the operational parameters of the MPD 93307 control module. 1) My measu...
Forum Discussion
problem resolved I cleaned and gapped the igniter the gap was about 3/32 set the gap to 1/8, The module now waits 7 seconds before it stops and indicates an error to test this I had to turn off the gas then turn on the heater. I not sure why doing this the module gives more time for ignition and why it fired up 100% of the time when I turned the water heater power on and off but wouldn't run overnight before I cleaned and gapped the igniter. Top signal is error light bottom signal is gas solenoid power
