Changing jumper between 2x6 volt
I want to change my 4 gauge jumper to a 1 gauge. Do I have to disconnect everything? Inverter, solar are direct to batteries. Disconnect switch for trailer loads. thx
Forum Discussion
Many years ago I did some studies on GC220 batteries and cable connections. Using the stud and wing nuts to connect cables is a loser.
Regular post clamps with the positive post being larger can pass almost twice the amperage. Not a factor if using smaller than 8 gauge wire but after that (increasing wire sizes) voltage drop comes into play.
An expensive system with Mattel grade connectors ain't where it's at.
Regular post clamps with the positive post being larger can pass almost twice the amperage. Not a factor if using smaller than 8 gauge wire but after that (increasing wire sizes) voltage drop comes into play.
An expensive system with Mattel grade connectors ain't where it's at.
