Changing jumper between 2x6 volt
I want to change my 4 gauge jumper to a 1 gauge. Do I have to disconnect everything? Inverter, solar are direct to batteries. Disconnect switch for trailer loads. thx
Forum Discussion
MEXICOWANDERER wrote:
Many years ago I did some studies on GC220 batteries and cable connections. Using the stud and wing nuts to connect cables is a loser.
Regular post clamps with the positive post being larger can pass almost twice the amperage. Not a factor if using smaller than 8 gauge wire but after that (increasing wire sizes) voltage drop comes into play.
An expensive system with Mattel grade connectors ain't where it's at.
Don't have posts, stud and a flat spot.
Trojan T-105
