Gererac model 09734-3 LP issue
hello, I'm trying to assist my neighbor with his LP fueled generator, but I don't have any theory about how it runs and I'm wondering if anyone could give me direction. Here's what I know. Using the s...
Forum Discussion
OK, we found the issue with the Generac LP generator not staying running!
There is a terminal block screwed into the frame about 8 inches below the voltage regulator. There are 4 blue 12VDC wires all labeled wire 14. 1 goes to the prime switch, 1 to J2 on the control PCB, 1 goes to the oil pressure and high temperature and the 4th I believe to a fuel pump that the LP version doesn't have. Anyway, the screw securing the male ends of the terminal block was gone and 2 of the wires had broken off the female spade terminal connector. I just stripped all 4 ends of the wires and wire nutted them together. Fired right up! Still need to order and replace the oil pressure switch, but the high temperature switch is at least in the game. So no switches or circuit board. Just connection, connection, connections.
Thanks for all the input!!!
There is a terminal block screwed into the frame about 8 inches below the voltage regulator. There are 4 blue 12VDC wires all labeled wire 14. 1 goes to the prime switch, 1 to J2 on the control PCB, 1 goes to the oil pressure and high temperature and the 4th I believe to a fuel pump that the LP version doesn't have. Anyway, the screw securing the male ends of the terminal block was gone and 2 of the wires had broken off the female spade terminal connector. I just stripped all 4 ends of the wires and wire nutted them together. Fired right up! Still need to order and replace the oil pressure switch, but the high temperature switch is at least in the game. So no switches or circuit board. Just connection, connection, connections.
Thanks for all the input!!!
