Labels for wire bundle that won't fall off
I need to label some split-wire loom cables. Some of the cable is in the engine compartment and some cable is beneath the (jeep) front bumper area - somewhat exposed to weather. At present, I've w...
Forum Discussion
jrloucks wrote:
What about covering/protecting the label with clear heat shrink? (This, of course, assumes you can slide the heat shrink over the cable.)
Similar to what I was suggesting with Clear vinyl film. Except the film will stick to the label and never get dirt in between the two. And doesn't have to be slid over the end of the wires.
Good thought though, i didn't know there was clear shrink tube.
