Main slide issue on one side
Hi all, I'm having issues with my main super slide. When bringing the slide back in it's as if one of the motors loses power or the communication signal is lost. So the one side just stops. I then ...
Forum Discussion
Having (2) 6 volt battery's connected in parallel is part of your problem.
Im sure you meant series connections for your 12v system correct?
Battery's have probably reached their lifespan but that's just me.
Since you have had an ongoing alignment issue thats probably key to your motor glitch.
Maybe that motor isn't properly aligned and it causes it to bind when retracting back in causing a small OL and then when load is off breaker resets until you do it again.
Find a good Electrician and have him check your amperage draw on that motor when it shuts off, probably drawing more than it should.
Im sure you meant series connections for your 12v system correct?
Battery's have probably reached their lifespan but that's just me.
Since you have had an ongoing alignment issue thats probably key to your motor glitch.
Maybe that motor isn't properly aligned and it causes it to bind when retracting back in causing a small OL and then when load is off breaker resets until you do it again.
Find a good Electrician and have him check your amperage draw on that motor when it shuts off, probably drawing more than it should.
