Forum Discussion

Silas_Carpy's avatar
Silas_Carpy
Explorer
May 11, 2022

No water pressure

2009 fleetwood pulse, dewinterizing. Drained holding tank and low point valves. Filled tank half way, turned pump on pumped up pressure and stopped. Flush toilet pump and water run. Turn on shower, hot and cold, pump and water run. Turn on either sink, pump runs about 1 second, stops, no pressure to either faucet. Anyone have any idea as to cause?
  • Y-Guy's avatar
    Y-Guy
    Moderator
    May 11, 2022
    Do check the sediment screen (if installed) on your pump itself. First trip out I had to dig around to clean mine out too. Was also my reminder to bleach the holding again.
  • MFL's avatar
    MFL
    Nomad II
    May 11, 2022
    ejmorgan wrote:
    Perhaps the sediment screens in the faucet outlets are clogged. Unscrew them to inspect and clean.

    Ed


    Likely this is problem
  • schlep1967's avatar
    schlep1967
    Nomad
    May 11, 2022
    Your symptoms act like a failed check valve. Why a check valve would affect both hot and cold for only the sinks (assuming when you say both you mean bathroom and kitchen) is a head scratcher. If it is just the hot water it would be the check valve at the water heater out line.
  • ejmorgan's avatar
    ejmorgan
    Explorer
    May 11, 2022
    Perhaps the sediment screens in the faucet outlets are clogged. Unscrew them to inspect and clean.

    Ed
  • way2roll's avatar
    way2roll
    Navigator II
    May 11, 2022
    Did you put your winterizing valves back to the normal position?

About Technical Issues

Having RV issues? Connect with others who have been in your shoes.24,199 PostsLatest Activity: Feb 17, 2025