PD9245C-14.8
I was trolling Best Converter and ran across a 9200C series doing bulk at 14.8v. Seems only in 45A for now. http://www.bestconverter.com/PD-9245C-148-45-Amp-RV-ConverterCharger_p_610.html#.VWPmaI9...
Forum Discussion
KJINTF wrote:
It's a simple modification to increase boost voltage from 14.4 to 14.8 or almost anything you desire. Pin #5 of the micro controller is connected to a 32.4KOhm resister - drop the value by several hundred Ohms and the Boost increases - Simply solder a 60KOhm across the resister in question.
Any chance you are still around here KJINTF? I have a PD9270 with the solid 14.8V boost modification from Randy and I want to lower that to 14.4V. I used the pendant for generator boost charging only and this is too hot for my new batts. I've looked over the board and the microprocessor (assuming that's it, where the pendant wires run into it) and I don't see any non-factory looking board-work and I don't see any kind of pin-out on the little black IC that is not obviously labeled on the main board. I know it's a decade ago but do you have any photos or could I email you a photo of mine and you comment on what resistor I need to alter? Thanks!
