Slide creeps out
We have hydraulic slides and one of our bedroom slides creeps out after a few days or so while in storage about 3 inches. Nothing appears to be leaking as far a a seal etc. What do I look for now ?
Forum Discussion
wolfe10 wrote:
Many of us interpret this as "hold until you hear the pump start to load up". Don't see anything positive by pressurizing past that point.
Well Bert I don't know who many of us are so all I can do is what HWH says. The following is right out of the HWH 725 Operator's Manual : To extend the room, press and hold the ROOM CONTROL in the "EXTEND" position until the room is fully extended or stops moving. Continue to hold the control to "EXTEND" three or four seconds. This assures full pressurization of the cylinders. IMPORTANT: Do not hold the extend switch more than 10 seconds.
It says the same under the retract section.
I do know that if the cylinders are not fully pressurized you can get creep of the slides.
