Slide out question
I have a 2010 TT that has a Lippert in frame electric slide out installed. The slide out contains the kitchen (less refrigerator) and 2 lounge chairs. It extends 18" out when extended and is 13 ft wid...
Forum Discussion
When extending before you say it started (remained)from up where it got to on coming in and stopping, went out two inches and then dropped to level.
Now you say going out it first rises to the up level, goes out an inch, drops, goes back up for the second inch then drops to level and continues out?
Please clarify the start position level for going out before and now.
Have to guess since our slide changes height at a different position from yours going out and in, but it does it by riding up ( when coming in) and going off that ( when going out) a plastic curved round-down thing the width of the slide 13 ft along the main floor outside edge. This plastic round down is screwed to the floor.
So my WAG is yours (which I don't understand where it could be since it is not at the outside edge of the main floor as described but inside somewhere, which makes no sense or you would trip on it all the time) has come loose and moves a bit when your slide goes out causing that down and up at the half way one inch out. The round down should be exposed when the slide is all the way out so you can check it.
I am not very happy with that WAG, but it is a start anyway.
Now you say going out it first rises to the up level, goes out an inch, drops, goes back up for the second inch then drops to level and continues out?
Please clarify the start position level for going out before and now.
Have to guess since our slide changes height at a different position from yours going out and in, but it does it by riding up ( when coming in) and going off that ( when going out) a plastic curved round-down thing the width of the slide 13 ft along the main floor outside edge. This plastic round down is screwed to the floor.
So my WAG is yours (which I don't understand where it could be since it is not at the outside edge of the main floor as described but inside somewhere, which makes no sense or you would trip on it all the time) has come loose and moves a bit when your slide goes out causing that down and up at the half way one inch out. The round down should be exposed when the slide is all the way out so you can check it.
I am not very happy with that WAG, but it is a start anyway.
