Solar question

Will do, thanks for the help. Did that on the solar that I put in my old trailer, I didn't set this up, and I can't see that it has any.

Mike

And add a fuse to your solar wire. All wires should be protected with a fuse.

You proabably need 8 guage wire from the batteries to the controller and from the controller to the solar panels.
Panels of different sizes are best not operated in parallel.

Sounds good. I will talk to them at the shop to try to avoid troubles again. Thanks.

Mike

Solar good. Install a heavy fuse right on the positive battery post, a lot less expensive to change.

Then find the largest 12V light you can and hook it in series with the positive battery cable. It must be large enough to not light the light or very dim with the parasitic rig loads. Now push/pull the wires and plugs until you find the problem.

Plus there should be burned/arcing evidence at the short as it takes a lot of amps to cause your problem. I don't suspect your solar as 10 ga wire would become very hot, but disconnect it if suspicious.

Also, the controller has been working good, charging up rapidly in the morning and getting up to 14.6 to 14.8 to start for the daily charging. Seems normal.

Mike

I didn't use the plugs, I used the configuration of the wires or the polarity of the wires as marked going + to plus and - to - . The problem I had was on movement of the battery case the wires shorted catching on fire and blowing the neg pole out of the right battery. Replaced the wire that looked like it was the one that shorted with a piece of PVC pipe to protect it, and both batteries since I want them to be the same age (6 volt), and everything was fine for a couple of trips. Then on another trip, hooking up to leave the lake, pulled on the plug to hook to the truck, blew up again and blew the neg post out of the right battery again. The fire extinguishers are getting expensive, let alone the batteries. I have it going in to the shop this week. Hope to get it figured out, I have a reservation at the coast starting Friday. Thanks for the reply's.

Mike

mike-uswest wrote:
I have been told that the wire used in the Arctic Fox is a 10 gauge hookup to the controller. It has been working fine for over a year, but I am having some shorting problems at the batteries,

I don't know what shorting problems are, but you're about at the limit for 10awg wire.

Check the polarity of each panel.

FYI Parallel panels should be closely matched for voltage, amps can be different. Plus it's best to always use the same type.

What does a "shorting problem at the batteries mean?" Are you suggesting it's from the solar or something else? They discharge to fast? etc

Shorted batteries can get hot quick while discharged batteries are another issue including failing batteries. Have them load tested.

Your panels can produce about 18 amps. 10 gauge wire can handle that without significant loss for 5.5 to 7 feet. Manufacturer was being cheap. Eight gauge costs a little more.