SuBurbank hot water heater
Hi. I have an SW6d. I replaced the thermostat and the electrode and cleaned the burner tube. I get the three 3 sets of clicking but it wont light. I manually lighted it and it stays lit until the c...
Forum Discussion
Harleyhippie wrote:
Hi. I have an SW6d. I replaced the thermostat and the electrode and cleaned the burner tube. I get the three 3 sets of clicking but it wont light. I manually lighted it and it stays lit until the clicking stops. I have even talked to Suburban and they don't know what the issue is. There's no problem with the gas flow.
Any ideas? I haven't had hot water since the beginning of November. It's getting old taking buckets of hot water into the shower :-(
You say 3 sets of clicking. But are you actually getting a spark across the electrodes?
You also say it will stay lit until the clicking stops if you manually light it. The flame goes out after the clicking stops?
It would have to be the circuit board or the wire connecting the circuit board to the electrode.
