Tekonsha P3 install, late model Ford
I bought a Tekonsha P3 Electronic Brake Control for my Ford E350 van. The instructions contain a warning sheet that says on some vehicles when the manual control is used the stop light switch can gro...
Forum Discussion
It's a 2013 with the canbus module system. It doesn't have the factory 7-pin setup. I bought the adapter to connect the P3 to the standard harness. I also have the 4-pin flat connector (installed & functional) to 7 pin connector, with a 2-wire cable heading up front for power & brake. Other than the red wire (vio/wht on the Ford side) everything is like a you-tube I watched.
Except a minute of you-tube done takes me an hour to do, longer if I have to add more parts.
Except a minute of you-tube done takes me an hour to do, longer if I have to add more parts.
