Transfer switch question???
I finally got around to installing an inverter and have question concerning transfer switch. A little information on what I have. I bought a 50A progressive dynamics xfer switch that I wired with prio...
Forum Discussion
smkettner wrote:mbrower wrote:If you mean Normally Open vs Normally Closed sides it is not an issue.
Everything works well configured this way but I do have concerns with the 50A relay switching loads backwards.
Even going the other way does not matter if you are switching power between two output paths.
As long as power goes one direction you are fine. Must travel from source to the load only.
That is correct, I have shore power running through the "designated generator " side of the relay (NO) and generator running through the "shore power" side of the relay (NC). I keep power on my camper 24/7 and was nervous about the relay coil staying energized.
