Show your mods!!
This is a removeable DVD stand I made out of conduit and wood for the back bunk in our Jayco 23B. swivels and tilted slightly. I also made one that will slide in the post where our regular TV sits for...
Forum Discussion
My wife has been telling me that she needed a light over the sink since we bought our Roo 23SS last summer. Tonight I added one.
First I removed the microwave and the support board from the microwave opening. The microwave is held on with 4 screws and the shelf board has a single screw in front. Then I measured for the light and drilled a hole down for the wires through the 1/4 inch plywood.
I measured very carefully and drilled a hole into the dead space below the cabinets over the couch. The space is about 1 inch deep and I made sure my hole was in the center of the space!
I pried down the thin plywood under the cabinets over the couch (it is held on with staples and was already loose) just enough to fish out the wires to the reading light. I used the clamp on splices to hook up my wires for the new lamp.
Hooked up the wires to the light and reinstalled the microwace support board and the microwave. Added a few small screws to the plywood under the cupboard to secure the plywood. Turned on the light and it made a huge difference!
First I removed the microwave and the support board from the microwave opening. The microwave is held on with 4 screws and the shelf board has a single screw in front. Then I measured for the light and drilled a hole down for the wires through the 1/4 inch plywood.
I measured very carefully and drilled a hole into the dead space below the cabinets over the couch. The space is about 1 inch deep and I made sure my hole was in the center of the space!
I pried down the thin plywood under the cabinets over the couch (it is held on with staples and was already loose) just enough to fish out the wires to the reading light. I used the clamp on splices to hook up my wires for the new lamp.
Hooked up the wires to the light and reinstalled the microwace support board and the microwave. Added a few small screws to the plywood under the cupboard to secure the plywood. Turned on the light and it made a huge difference!
