cancel
Showing results forย 
Search instead forย 
Did you mean:ย 

6volt batteries in older Northern Lite

Akjoatmon
Explorer
Explorer
Has anyone put 6volt batteries in series in an older Northern Lite 10-2? I am in the process of upgrading DC power (new converter, batteries and wiring) on a 2004 Northern Lite 10-2. The problem is the 2 single battery compartments are located on opposite corners of the camper. Luckily there are a couple of 2awg cables already installed that I could use to connect the batteries, but the distance still concerns me.
8 REPLIES 8

covered_wagon
Explorer
Explorer
I suggest just doing the two larger 12 volt batteries in parallel. Factory puts in too small of 12 volt batteries and larger 12 volts do fit. It much simpler saving the big wires for a future generator.

Some well planned solar panels will be a big plus.

Getting rid of the old convertor would be number one on the list. You need a good 3 stage charger to not ruin any new batteries. Which those old style convertors do damage.

AnEv942
Nomad
Nomad
"from a load balancing standpoint"..
Which is my assumption.
To achieve the same with 12v batts in parallel requires a 3rd cable, otherwise 1st battery sees more of the load & charge. Greater the distance more it affects.

With 6vs and 2 existing cables between-done. Distance really not an issue. Hence easier in opinion.
01 Ford F250 4x4 DRW Diesel, 01 Elkhorn 9U
Our camper projects page http://www.ourelkhorn.itgo.com

burningman
Explorer II
Explorer II
Well actually itโ€™s exactly the same effort to wire them. Itโ€™s still two cables you just connect to different posts on the battery.
With 2-gauge cables you should be fine.
Two 6s in series is more advantageous in this situation from a load balancing standpoint, since all the load has to pass through both batteries in a single electrical loop.
2017 Northern Lite 10-2 EX CD SE
99 Ram 4x4 Dually Cummins
A whole lot more fuel, a whole lot more boost.
4.10 gears, Gear Vendors overdrive, exhaust brake
Built auto, triple disc, billet shafts.
Kelderman Air Ride, Helwig sway bar.

AnEv942
Nomad
Nomad
Agree, 2 6v easier to wire with 2 cables

Just ensure cables marked/labeled for fool(me) proof connecting.
01 Ford F250 4x4 DRW Diesel, 01 Elkhorn 9U
Our camper projects page http://www.ourelkhorn.itgo.com

time2roll
Nomad
Nomad

Son_of_Norway
Explorer
Explorer
I don't have a truck camper, but I will make a comment about distance between batteries. I have two separate battery compartments that are about ten feet apart. There is a slight voltage difference during discharge and charge between the two, about .2 volts, with the distant battery having the lower voltage. I don't have 2 awg though, more like 6 awg. With 2 awg I don't think that any difference will be enough to worry about.
Miles and Darcey
1989 Holiday Rambler Crown Imperial
Denver, CO

Mandalay_Parr
Explorer
Explorer
I wouldnโ€™t worry too much about the distance.
Jerry Parr
Full-time
2005 Mandalay 40B
Cat C7 350, 4 Slides
Blue Ox, Brake Buddy
2004 CR-V Toad
jrparr@att.net
602-321-8141
K7OU - Amateur Radio
Kenwood Radios
ARRL, W5YI, & LARC VE
SKYWARN Weather Spotter

Lwiddis
Explorer II
Explorer II
Why are you apparently only concerned about two 6 volt batteries and distance?
Winnebago 2101DS TT & 2022 Chevy Silverado 1500 LTZ Z71, WindyNation 300 watt solar-Lossigy 200 AH Lithium battery. Prefer boondocking, USFS, COE, BLM, NPS, TVA, state camps. Bicyclist. 14 yr. Army -11B40 then 11A - (MOS 1542 & 1560) IOBC & IOAC grad