Bigfoot 2500 Underbelly, Thoughts and Pics
Starting on a project on the camper (Bigfoot 2500, 10.6) and as part of it, I needed to remove the bottom panels of the camper to see where the tanks are. I took some pics and stitched them together t...
Forum Discussion
If you read this before installing, I doubt hardware store holy angle (that’s what we call it) will span the 4’ or however wide and not bend under full tank of water unless you install more pieces than you think is necessary.
Depending on the vertical space you’re working with and the ledger or side attachment points, lumber or heavier gauge angle would be mo betta.
I redid my tank supports when one strap finally bit the dust (using camper off the truck, full of water) with scrap around the house which happened to be leftover 1x4 yellow cedar deck boards. I did re attach the straps just because and I did provide for airflow from to back even though I’d have never needed it.
Depending on the vertical space you’re working with and the ledger or side attachment points, lumber or heavier gauge angle would be mo betta.
I redid my tank supports when one strap finally bit the dust (using camper off the truck, full of water) with scrap around the house which happened to be leftover 1x4 yellow cedar deck boards. I did re attach the straps just because and I did provide for airflow from to back even though I’d have never needed it.
