Clearance Lights - Replacement
I have found it necessary to replace a couple of bulbs in my 2008 Lance clearance lights. Are the lens held on with screws or simply held there by the sealant? If so, do I just pry them off to gain ...
Forum Discussion
Bumpyroad wrote:
I think that that is the primary reason "macho men" want them. but for safety, etc. wouldn't just two, one on each front corner suffice?
bumpy
THe manufacturers of vehicles and RVs install them for a reason - to meet FMVSS108 / CMVSS108 saftey standards. They aren't there just for "macho men".
www.ledtrailerlights.com has some nice LED replacements, which is where I got mine a few years ago.
One at each corner ius sufficient, unless the vehicle is over 80" wide, then the three center ID markers are required.
Furthermore, it's a little unsightly to remove lights and just plug up a hole where a light used to be, which is why the OP wanted infor on removing / replacing them.
