Drill motor for stabilizers
Looking for recommendations on which cordless drill I should buy for raising and lowering my stabilizers. Appreciate any advice. Thanks.
Forum Discussion
I prefer drills to impact drivers for that job. Much quieter and fully up to the job as long as you opt for 18v or higher. I used a DeWalt 14v for a while and it did the job ok, until it suddenly didn't. I've been using a Ryobi 18v drill for quite a while now. It's way more than enough.
Keep your stabs clean and lubricated too. It helps.
Keep your stabs clean and lubricated too. It helps.
