Ref. blowout
New to forum....maybe posted before but can't find it. My ref.(on propane) when going down the highway, blows out. Don't have 12v. Wind or speed doesn't matter. Always have to relight. Help please
Forum Discussion
Years ago I went through this and ended up getting an aftermarket control board...
Solved all the flame out related issues and actually have a way of adjusting the temperature on the board.
http://www.dinosaurelectronics.com/Dom_boards.htm
Note the retry for flame out...
Spec:
*Built in Ignitor.
*2-way or 3-way operation.
*Fuse protected.
*Variable Temperature adjustment for those FIXED TEMP refrigerators.
*The CHECK light comes on after each ignition try fails to sense a flame.
*Repeats the 3 try ignition cycle at 30 minute intervals if no flame is sensed.
** In 3-way models, the DC element will drop out and the DC mode light will flash, if the voltage level falls too low? for more than 10 seconds.
*Easy to remove cover included
Jim
Solved all the flame out related issues and actually have a way of adjusting the temperature on the board.
http://www.dinosaurelectronics.com/Dom_boards.htm
Note the retry for flame out...
Spec:
*Built in Ignitor.
*2-way or 3-way operation.
*Fuse protected.
*Variable Temperature adjustment for those FIXED TEMP refrigerators.
*The CHECK light comes on after each ignition try fails to sense a flame.
*Repeats the 3 try ignition cycle at 30 minute intervals if no flame is sensed.
** In 3-way models, the DC element will drop out and the DC mode light will flash, if the voltage level falls too low? for more than 10 seconds.
*Easy to remove cover included
Jim
