aurcor
Explorer
Joined 6 years ago
User Profile
User Widgets
All Activity
Atwood oven burner wont ignite
my wedgewood by Atwood oven stopped igniting all of a sudden. The burners work fine, and the pilot lights fine, but does not ignite burner bar. I replaced the safety valve which came with a new thermocouple. Same results... no ignition. It is a basic 3 burner stove with oven. no electronics. any ideas? tia CJ831Views0likes3CommentsRe: dometic thermo prob
UPDATE - I went ahead an purchased the upgrade kit from Dyers RV online. (we got the 5th wheel for one dollar, and we are going to keep it, so it was worth it) Just got Back from Montana, and it was in the mail. So I put it in today. I had EE error code on the thermo, once I reconnected electrical. I did a 5 button CCC reset and it worked. However, only one mode showed, so I had to turn the furnace DIP switch to ON and performed another reset. We are working again! thanks for all your suggestions. and assistance!!680Views0likes0CommentsRe: dometic thermo prob
I guess I will use the existing cable if it may be too difficult to install a new one. It should be ez to reconnect the plug I cut off to the wire hanging out of the wall... following the colors on the cable. (matching each color, assuming the other end is reversed)680Views0likes0CommentsRe: No Hot Water
with my limited knowledge If you already checked all the other stuff... I would check that clear plastic thing in the middle of your picture, above the burner (with the wires going to it). I had to replace ours when I didn’t get the ’click’ burn! I got 2 for about $15-20, connected it and whoosh. started at the easy stuff.658Views0likes0CommentsRe: dometic thermo prob
thanks again! We are keeping the RV so I will get the upgrade kit. (Thanks Doug) Instead of reconnecting the jack on the TSTAT side. would this work? https://www.dyersonline.com/dometic-a-c-18ft-communication-cable.html Also, what change came with 5 button? just zones? Regs, cj680Views0likes0CommentsRe: dometic thermo prob
thanks all. it is a 97 Mobile Scout 33RK We don't really use the AC but am going to need to get heat going asap. Overnight temps already dipping to low 30's. There is only one AC. I did check the only fuse I could see in the heater compartment, and it was not blown. I found some CcC units on Amazon (4 to 5 button) If those will work i will purchase one of those. First I would like to check the sensors (?) and see if I can't get the backlight going again on the old one. and I can re-terminate the cable with the plug so there is no funky splicing. I will let you know how it goes. CJ682Views0likes0Commentsdometic thermo prob
Hello, new to RV life and this forum. Recently my wife complains that our thermostat doesn't shut off properly. It did keep the heat on one time until we were cooking (way above set temp). [ dometic duo therm comfort control center with phone plug connection] I finally bought an inexpensive replacement on Amazon. [White Rodgers 1C20-101 Economy 24 Volt/Millivolt Heat Thermostat] And thought it should work for our heating/cooling needs. Last night I traded it out by cutting the wire with the RJ-8(ish) plug and connected the wires to the new thermostat, following the chart provided by new thermo mfg. It did not work. So I re-connected the phone plug to the original cable and inserted back into our Dometic CCC thermostat, and nothing. No backlight screen or anything. Note: while I was trying to connect the new analog thermo the Red and Green wires touched long enough to smolder and melt some insulation. I'm willing to take common 'you did what?'s' in replies in my ignorance, but don't forget to provide a possible solution. thanks in advance3.3KViews0likes14Comments
Groups
