All ActivityMost RecentMost LikesSolutionsRe: Winterizing water tank.how is that work, look up in there to see if the valve is opening or the handle is just moving and has broke of the gate partRe: awning rail attachmentsounds good to meRe: New Redwood Need New Truck HelpF-450 6.7Re: Help with gpsAlpine in dash works greatRe: Dog liability insuranceTry looking in the AKC websiteRe: Portable generatorYour Cpap is 12 volt the box on your 110 plug converts it to 12 volts get an adapter . how about the microwave ? I would just get a 2200Re: Palm Springs to Paso Robles options?10 to 15 15 to 210 210 to 118 118 to 23 to 101 118 is a shorter path and better way to go than 126. you can also run 134 to 101 but be ready for stop and go PS I live in VenturaRe: sorry, another tire questionThe E is a better tire, the side wall is stronger LT tire side walls have more side to side play and a higher RR than the trailer tires.Re: Unsolvable Mysterysolar did you unhook the truck ?Re: Broke Our SuperGlider rhagfo wrote: X3 TOO HIGH!!! I stated this in another post! WHY, WHY, WHY do users think you need to see daylight between the hitch head and the pin plate when Unhitching or hitching! If the hitch was designed to work that way the hitch head would be just a flat plate without the ramps. I usually hit the hitch about 1" low have been as low as 2" still works! I have read in other threads about hitching issues, "I don't want to stress the hitch or pin box"! Trust me towing down the road puts FAR more stress on the hitch and pin box than hitting it with the pin plate low. The reason you hit it low is to prevent "High Hitching", this is where the pin ends up on top of the jaws or bar, first big bump and bye, bye 5er. This is the reason I hit low and still do a pull test with the landing gear still down on the ground supporting most of the 5er weight, easier to overcome friction with less weight on the pin. I don't block my landing gear so the slight movement doesn't harm the legs. mileshuff wrote: When hitching I set the kingpin just slightly below the level of the hitch plate and let it ride up. About 1/8" below. When unhitching I raise the trailer until I just barely see a gap, maybe 1/16". Never a problem. When I first got my hitch and 5'er I raised until I saw the kingpin begin to slide slightly on the hitch as the weight is unloaded. Maybe 1/4" below where I'd see a gap. This always caused me problems with it not releasing easily. With a very small gap it glides out every time. You are still flirting with issues,really 1/8", is that with the back to the hitch head tilted down in the back or level. well put sir you hit the pin on the head !!!
GroupsBucket List Trips Bucketlist destinations you just can't miss. Which spots stick with you?Jan 11, 202513,487 PostsFifth Wheel Group Interested in fifth wheels? You've come to the right spot.Jan 13, 202519,006 PostsMotorhome Group Join in here to discuss all things motorhomes.Jan 14, 202538,705 PostsPet Owners Notes from the road with the best travel companions around.Dec 29, 20242,081 PostsRV Newbies We all start out new. Share lessons learned or first-time questions!Jun 15, 20174,026 Posts
Bucket List Trips Bucketlist destinations you just can't miss. Which spots stick with you?Jan 11, 202513,487 Posts
RV Newbies We all start out new. Share lessons learned or first-time questions!Jun 15, 20174,026 Posts