All ActivityMost RecentMost LikesSolutionsFresh water tank broken exit tank elbow to the 12v pump2004 Fleetwood Wilderness 250RKS. 40 gallon fresh water tank. Black elbow O.K. but the white fitting is sheared at the tank level. Compression/hose clamp end is 14" ID. Tank end on the black fitting is 5/8". OD on the white fitting is 1-1/8" not including the two finger/spanner wrench protrusions. Please ID a complete part and part number and most important how to remove the sheared white portion. Thanks. Atwood L.P. gas water heater spark ignition gas cutoff heat unit not workingHello all, I have a six gallon Atwood SPARK IGNITION L.P. gas water heater and I'm doubting that the automatic gas shutoff feature is working once the tank temperature reaches a certain factory prescribed level. Last week in the morning it was 60 degrees outside temperature and it ran for over twenty minutes without automatically shutting off so I manually flipped off the onboard switch as the hot water in the trailer was very hot to the touch-couldn't keep my finger under it. I really don't want to run it until the auto cutoff possibly kicks in somewhere after twenty minutes or doesn't work at all due to possible damage/fire. What would be the part that I might need to control the auto L.P. gas shutoff when maximum heat/temperature has been achieved? My Atwood SPARK IGNITION manual has something called a "Thermal Cut Off" part number 93866 is that what I need to replace or is it something else?? Please see the photo and the highlighted component. (I don't see an image attachment here) but the part has a brown wire and a clear plastic tube with metallic components inside. Serial number: 96220353449 Spec number: 220113 Thanks in advance.
GroupsTravel Trailer Group Prefer to camp in a travel trailer? You're not alone.Mar 01, 202544,026 Posts