splegge
Explorer
Joined 19 years ago
User Profile
User Widgets
All Activity
Slide out off by 3-4" when open/ Flush when closed
Went on a family trip and after a good east cascade rain storm, had a rather wet RV... around the back slide. after getting home and opening up for a drying, I notice the back slide one side is flush and the other is off by 3-4 inches, but only when open.... Also appears the outside support rail, is bent(farthest away from RV) Thoughts .. Is this slide just out of whack? Or is there another sinister reason why bent and out of sink? Thanks RV folks....716Views0likes3Commentsunderbelly sheeting - ideas on how to repair
Blew a tire and noticed that the protective plastic sheet that covers the underbelly in the wheel well was damaged (part torn and part melted. I also noticed another seem area going from underneath to into the side where this sheeting material has shredded. This protective material is like a woven plastic tarp. Has anybody ever repaired this material? I was thinking using some sore of rubber spray sealer or apply/paint on the plastic sealer like you dip your tool handles into. the primary repair area is about 6 x 12"2KViews0likes9CommentsMax Air II vent to low to roof - rubbing
Hi all, Installed max air II vent last fall. had clearance 1/8 -1/4 inch all the way around so no edges wear contacting roof. After cleaning and inspecting I see the rear of the cover is contacting my roof. My thoughts are it will wear a hole or tear ...... has anybody else had this problem? Thoughts on raising or bending it up or pop the cover open and dremel 1/4 to 1/2 inch off the bottom?552Views0likes2CommentsRe: Tow Vehicle Gas/Diesel?
Had 5800 LBS trailer Towed with Ford Exp 4.0 and got 9-11 MPG. Upgraded TV 2006 3/4 burb with 6.0. same milage 9-11 MPG when towing. But having the extra TV size, 100 HP and torq was a dream come true. F.I.L. has a 2011 on it Ford w/ Diesel b20 6.7 w 40K mile and getting 15 MPG towing in mountains of WY. Would imagine that might bump up on flat lands.484Views0likes0CommentsRe: Power Tongue jack and rear door clearance problem- Need help
I ended up rotating 180 degrees. LOL my gas cover the propane would not go on!!! Also when looking at the lift head, there are not 90 degree offsets - meaning there are only two position for the head. Dealer said will tap new ones in....308Views0likes0CommentsPower Tongue jack and rear door clearance problem- Need help
Hi All- I am unable to open my rear door all the way since the power jack in the way – Has anybody else had this problem and how did they fix(reposition the jack) to allow the rear door to open all the way? is it possible to rotate the jack 90 degrees?2.2KViews0likes9Comments
Groups
Travel Trailer Group
Prefer to camp in a travel trailer? You're not alone.Jul 03, 202544,041 Posts
