Our trailer is a 2005 fiberglass and is a case where the inside was better than the outside. I suspect it has some sort of sun damage. Underneath the license plate and on 1 side, it is still shiny. The rest of the fiberglass is fairly dull. No bla...
Does anyone know of some type of spool or spindle or Something to wind the electrical cord? The cabinet that ours retracts into has quite of bit of storage room, but the cord just lays on the bottom and gets tangled. Any advice appreciated! Thanks...
I am interested in replacing our indoor trailer lights with LED. Are there "warm" softer LED instead of the bright colder bluish lights? If so, where are they purchased? Thanks!
We are replacing our outside shower box and faucet. What do we use to seal or caulk around the box? Can this also be used to caulk/seal around a new city water inlet device? Thanks!
We need to replace the fitting for where the water hook-up attaches and enters our trailer. Ours on our 2005 Adirondack leaks a great deal. What is this item called and where would I purchase it? Thanks!
Also near Cincinnati. We are leaving March 26. Surprised to find that some Georgia state parks and most COE not open then. Better make sure the Kentucky park is open before you leave.
We used room darkening fabric cut slightly larger, held up with Velcro. Left in place on hot days, removed on cold days. Left up each night to prevent early morning light.
AMXPress and old guy: If you have a link for your purchases, I would love to see it. Our camper is in storage and I am unsure of brand. But ours too had weak clips and keeps falling on the floor. Thanks for any help!
Dumb question-- How does one know if we have the automatic switchover? What does it look like? Also we were told the propane tanks cannot be refilled after ?10 years? Person made it sound like this was a law? Our trailer is a 2005 so this will be a...
page 33 from manual: See #4 (cannot get it to bold)Manual Operation of the Slide out Mechanism1. It is necessary to disconnect 12 volt power from the slide out motor. The 12 volt power can be disconnect by turning the disconnect switch to the off po...
