All ActivityMost RecentMost LikesSolutionsRe: tailgate hits camperWhat I do is not lower my tailgate all the way down. I take the cable that keeps the tailgate from falling down and loop it around the latch pin, that way the tailgate is part way up and part way down. It is low enough for me to back under my pin hitch but not low enough to hit the trailer.Re: Longbed tailgate will hit camper when hitchingWhat I do is take the cable that supports the tailgate and wrap it one time around the piece that the tailgate latches to. That will the tailgate is only part way down. It misses the king pin when I back up and give me room to hitch with out raising the tailgate all the way until I am hooked up. If that doesn't make sense I can take a pic and post it.Re: Anyone familiar with LCI Ground Controller 2.0 (Electric)I had a problem with one rea r jack this spring. Lippert sent me a new control board and that took care of the problem. You can get a set of jumpers and jump each jack directly from the battery to check the wiring itself. Lippert had me do this as a part of trouble shooting the problem. Another suggestion I would make is disconnect the power going to the control board and let it reset itself. Not the control panel but the control board itself.Re: Question re: shotgun in MHIf it is a long gun and it is unloaded and in a case you are good to go with it in your camper in any state. Hand guns can get tricky.Re: Halibut/Salmon fishing charters in SewardWe used the guys at the Hardware store right across from the docks, got lots of fish and the crew and equipment was great.Re: RV plugged in noise at electrical panelA loose breaker in the panel can make a humming and clicking noise make sure they are well seated.Re: So where will you be???South Higgin Lake State Park in Michigan, beat the traffic and arrived yesterday. Watching them trying to finish up paving the roads in the camping area.Re: Undercarriage Fabric Repair on TTIn the area on my trailer that was already ripped I covered the whole area with FRP board from Home Depot. I covered the back side with Liquid Nails and then screwed it right to the plywood. In the areas that had not ripped yet I sprayed it with the rubber waterproofing similar to that advertised on TV. When that area shows more wear I will probably cover it with FRP also.Re: Pantry drawerI can see it in my post, not sure why it is not showing up for others?Re: Pantry drawerHmmmm, can you see it now?
GroupsBucket List Trips Bucketlist destinations you just can't miss. Which spots stick with you?Jan 18, 202513,487 PostsChefs on the Road Campground recipe recommendations, restaurants, and more!Jan 01, 20252,135 PostsFifth Wheel Group Interested in fifth wheels? You've come to the right spot.Jan 13, 202519,006 PostsMotorhome Group Join in here to discuss all things motorhomes.Jan 22, 202538,705 PostsTravel Trailer Group Prefer to camp in a travel trailer? You're not alone.Jan 21, 202544,029 Posts
Bucket List Trips Bucketlist destinations you just can't miss. Which spots stick with you?Jan 18, 202513,487 Posts