All ActivityMost RecentMost LikesSolutionsRe: Looking for some help deciding on which batteries.....update on trojans in quartzsite i bought 6 t105's in quartzsite today @ $125.00 plus their 3% solar taxRe: Jayco Seneca vs. dynamax force GL wrote: dcason wrote: As the owner of a Jayco C, I wouldn't buy one again...I would go better quality. You don't have a Jayco Seneca though, do you? That's their high end Super C, so I'm guessing (hoping) that the quality would be better. as an example pick up an interior door of my 2008 haulmark and then an interior door from our past 2010 seneca. black walnut does weigh a lot more than particle/fiber board or whatever that veneer was.Re: Super C yrusoslo wrote: If sky is the limit, Haulmark on a Volvo Chassic X2Re: Change of Plans!welcome to the forum what you have there is referred to as a truck conversion. much different than a "super c". you could put a tow bar on a super c and use it for your toad. (overall length may be a problem) we have a haulmark 3303ts pictured in my profile. IMAGNLife.com wrote: Lol. Sorry gang. The Super C at the show was a Showhauler 45 footer. And since researching them we've come across units made by Renegade as well. We plan on visiting both facilities in Indy before making a decision. Anyone with experience with either? Thanks! - JB Re: rear overhang/clearance issues?"Is scraping/rubbing the rear bottom of the coach an issue?" how can it not be? made this for our haulmark and it's touched down a few times. it lets you go places you shouldn't go. Re: Water pump "pulses"ice maker?Re: Help with Jayco Seneca 37TSget a quote from rv direct and use it in your negotiations with other dealers. donRe: LadderFEATHERLITE Item #5435-754 Model #2708Re: Picture of Wrangler base plate installationthat plastic piece your talking about is referred to as an air dam. mine was steel but both will require some "triming"to make work. it's all in the blue ox instructions. some say the air dam reduces "hood flutter"??? warranty issues?? google, airdam hood flutter jeep wrangler jk when your removing the air dam it will be fastened with plastic fasteners that cost about $9.00 a peice. a phillips screw driver while holding the outer part while turning will get them apart. Re: Picture of Wrangler base plate installation MetalGator wrote: Don McL wrote: this is on our 2014 jkur x Great pictures. Do you have a picture of the front of your Jeep with the finished install? my jeep is a 2014 rubicon x which has the same bumper as the 2013 10a (10th anniversary), which is completely different bumper than your sahara. below are pictures (not of mine) the one on the left is a 2013 10a and the one on the right is a 2014 rubicon x. (notice the amber and clear lens)