All ActivityMost RecentMost LikesSolutionsRe: Onan Maquis 7000 in 93 Holiday Rambler Fuel Pump IssueMy pump was stuck from probably the skunked gas as my carb bowl was full of stuff, mine ran after changing pump and cleaning bowl but I know carb either needs rebuild or replace to work well.Re: Onan Maquis 7000 in 93 Holiday Rambler Fuel Pump IssueStuck fuel pump, clogged carb replaced pump, somewhat cleaned carb enough to run but will replace in springRe: generator wierdnessOn my 93 Holiday Rambler both AC Units operate together but only with Generator running. I original figured only one would run like with Shore Power but was pleased to see that both come on with Gen running. Since breaker was popped need to check output voltages and amperage etc. hope this helps...Re: Onan Maquis 7000 in 93 Holiday Rambler Fuel Pump IssueGot it working, thanks for all the help and the manual!!!Re: Onan Maquis 7000 in 93 Holiday Rambler Fuel Pump IssueDon't make sense unless mine was rewired a fuse should be right where you can easily replace it.Re: Onan Maquis 7000 in 93 Holiday Rambler Fuel Pump IssueKpackpackkelley, Thank you, this helps in a lot of ways funny thing is in this manual it shows the F2 fuse located in the cover of the control panel but on mine cover has nothing other than F1 Fuse and Start Switch. Must be a year change thing or something along them lines. I we assume it is a Spec D version then Fuse more likely is on back of Air Cleaner adaptor. Guess I am going back out there and see if I can locate it. Checked it nothing attached to back of Air Cleaner, guess I will have to trace all the wiring out until I find the fuse, doesn't make sense it would be inaccessible, maybe someone may know where it is located. In looking at Schematic Fuse F2 protects the Fuel Pump, K4 Relay and Choke MikeOnan Maquis 7000 in 93 Holiday Rambler Fuel Pump IssueHello, I have a problem locating the F2 Fuel Pump fuse on my Onan Marquis 7000 Model # 7NHMFA26106C in my 93 Holiday Rambler I have replaced the bad pump with new pump, no power on + wire to pump which I suspect is a blown F2 Fuel Pump Fuse. Unit will start if cranked and spraying fuel down carb throat but no start with pump directly powered. The Fuel, Ignition and Choke are all on this circuit so I need to locate Fuse to eliminate it as a potential reason. From Net research it should be in line outside on right of control panel but it isn't. Any help would be appreciated. Mike