wilson86
Explorer
Joined 12 years ago
User Profile
User Widgets
All Activity
Re: Generator and Electricity Issue
Thanks for the info Tom. One thing we did do was start the generator and continue holding the start button but still did not get any power. How long do you think I should hold that button when starting to build the current? If this is how Generac works then this is good news and I am just doing it wrong. Which is a simple fix.486Views0likes0CommentsRe: Generator and Electricity Issue
I finally was able to get some assistance with troubleshooting the generator. One thing we found out is if we start the generator and its not producing electricity if we hit the start button (while engine is running) again the generator starts producing electricity to the trailer. Has anybody seen something like that? I think the brushes are fine on the generator. So it may just be one of the electric boards.486Views0likes0CommentsRe: Generator and Electricity Issue
MrWizard wrote: Shut down, with no power output on restart, sounds like a, bad control board in the generator Yes it could be an ats failure but that seems less likely to me Ats failures are often stuck contracts, there is no shore power mentioned and if the contracts we're stuck it should be stuck in the generator input mode If I go down this path would this be what I want to replace? http://www.partsfortechs.com/asapcart/92234-0922340srv-generac-generator-control-board-092234-p-103.html Thanks for all the replies so far!!! Matt486Views0likes0CommentsGenerator and Electricity Issue
Hello, I am new to the forum and tried to do a search for my issue but could not come up with anything. So I have a Generac/Onan Generator on my Carson Rebel. So basically sometimes when I start the generator I have power in my RV and other times it just does not work. So if I was to go out to my RV which has been sitting and startup the generator I will have power. I can let it run for 15 mins or however long I need. Once I shut the generator off and if I want to start back up generator will run but no power. Basically at that point I shut down the generator and if I let it sit for 30mins or an hour and start it back up I will get power. I cannot figure out why sometimes I get power and others I don't. I dont know if I have a bad ground some place or not. With an issue like this what are somethings that I should look at first? Generac Primepact 50 with Onan controls is my setup. Thanks in advance for any info. Matt5.2KViews0likes20Comments
Groups
