All ActivityMost RecentMost LikesSolutionsRe: What did you do to your Class C MH today???John, that is how my problem started. Turns out in my case the water got in under the bed and just laid in there. When my seams started coming apart it was because the screws that hold it together and the wood were both rotted out. I hope this is not your problem, but it sounds very familiarRe: What did you do to your Class C MH today???Sorry...with a sawzall that is.Re: What did you do to your Class C MH today???I cut the cab over off with a and threw it away because it was rotten and moldy...I am now trying to figure out what I'm going to do tomorrow. Does anybody know where I can get the fiberglass sheeting for a custom rebuild job?Re: What did you do to your Class C MH today???Had the tranny rebuilt on Weds...1200 miles from home.Re: What did you do to your Class C MH today???Terry, Advanced Auto Parts. It was actually a Mr. Gasket Micro Electronic Fuel Pump #42S rated at 2-3.5 PSI. Good luck. -ScottRe: What did you do to your Class C MH today???Pulled the OEM fuel pump out of my Onan Microlite and installed a 3 psi Gasket Master electric fuel pump on the frame in front of the genny. Started right up and ran like a top! No more shutting down because the fuel pump overheats. Now I'm going to climb up on top and beat my chest like an idiot.Re: What did you do to your Class C MH today???I have been waiting all week to work on my '94 Coachmen. I've got big plans but it's been way too hot all week to work on it after work. So now it is finally Saturday, I got up early this morning to get started and it's raining cats and dogs with no relief in site. I guess I'm going to have to get off this computer at some point and just get wet. I'll be reinstalling the genny with a new fuel pump, replacing battery leads, and going over the undercarriage with a fine tooth comb. 19 Days 'till Oregon!