All ActivityMost RecentMost LikesSolutionsRe: New electrical issueReplaced the converter and the heating element. Everything works as deigned now with no issues. Total cost was $170 and about 2 hrs of time. Thanks all for the info and help.Re: New electrical issueGoing to replace both. I think I might even have a GFCI laying around here somewhere. Thanks guy. Really appreciate it.Re: New electrical issueI did the 120x120v / 325w calculation and it comes out to 44.3, so the 45.5 resistance is good or outside the limits ?Re: New electrical issueSo I removed the heater element. Tested it with my meter set at 200 ohms on the meter and it reads 45.5 , So I am assuming this would mean that it has a short in it ? An I need to order a new one ? THank you.Re: New electrical issueI turned the Propane on and ran the Fridge on the propane. Took a while to light because of the air in the lines. But it did run on propane. And the GFCI will not trip unless the Fridge is turned on. So what part on the fridge should I consider replacing ?Re: New electrical issueThanks guys ! Will check it out. Appreciate your time.New electrical issueFirst, Thanks for all the help received with my power converter problem. My factory one was bad. I replaced it with a power max which was a simple fix and less expensive then what I was expecting. Next. My AC, fan and lights etc are all working as designed. The only issue I am having is with the BATH GFCI outlet and the fridge. With the camper plugged in, the batter cables connected, the battery reads 13.12 V at the battery and 13.10 V at the lugs in the panel. all breakers in the on position, and the GFCI receptacle on, if I turn the fridge on, the BATH GFCI will trip at the GFCI. In a few minutes the CHECK light on the fridge will illuminate. This happened with the old power converter as well. It is the only thing that has stayed the same. Also, If I turn the all the breakers off in the box, the fridge buttons will still illuminate. Is the fridge 12 V ? Thanks againRe: Converter Toubleshooting QuestionSounds like a plan. I'll look into one. Thanks for all the input.Re: Converter Toubleshooting QuestionI can replace the resistors. they have no markings on them that I can see. No screen printing at all unless they put it where you cant see it without removing them. I hate to throw away something that just needs resistors replaced.Re: Converter Toubleshooting QuestionI pulled the converter and looks like there is some burning around the 2 ceramic blocks (resistors) on the circuit board. Also there is one wire that has some prelim burn on it that is next to the ceramic blocks. I am having a friend take a look at it to see if he can fix it.