All ActivityMost RecentMost LikesSolutionsRe: New TPMSMy system has 1 sensor that reads 2 to 3 psi lower. I verified with an independent gauge and now I just factor in the difference.Re: peak traffic times in citiesThanks for the replies. I will study the patterns with google. I wont be going until July. Thanks again and safe travels.Re: peak traffic times in citiesThanks Mitch. It seems like I just have to watch rush hour times. I can always take a break before entering a city if the time isn't right.Re: peak traffic times in citiesI agree with Sunday mornings but I can not take a week between each city. Just kidding.Re: peak traffic times in citiesThanks pcm1959. That is good info. I was just wondering if there was a website that would provide that type of info. It sure would be handy.Re: peak traffic times in citiesplease be more specific. 3 and 6? I assume that is not in the morning. What about in the morning. Does this apply to all cities or is this just your opinion?peak traffic times in citiesDoes anyone have a good resource to determine the best time to pull your camper through a major city?Re: Furnace problemThanks for all the replies. Turns out that the control circuit board is defective. I checked connections, voltage, air flow blockages, etc. While I had the outside cover off to check connections, there was a troubleshooting chart for the diagnostic LED on the circuit board. I turned the unit on, observed the LED during the fault condition and communicated the results to Camping World where we bought the 5er. They are going to order a new board based on my word and will install it the next time I am in the area, as they are 100 miles away. Looks like we are on the road to recovery. It helps to be thorough in your data gathering to gain credibility with the dealer to resolve issues over the phone instead of travelling to their location each time. Thanks again for the ideas that helped get me to the source of the problem.Re: Furnace problemI will get the furnace info as soon as the rain stops and post it. ThanksFurnace problemMy furnace worked fine last Thanksgiving. Made a little trip this week and it got down into the 30's. Turned on the furnace and here is what happened: Blower turned on, I heard the burner ignite, ran for a little while, burner and blower stopped at the same time, few seconds later the blower came on, burner restarted, ran a little while and the cycle repeated, the amount of run time was not the same it varied from a few minutes to a few seconds, After a several cycles I waited for the burner and blower to stop and then switched the unit off at the thermostat. The blower then came on to cool the heat exchanger and then turned off. Any ideas?
GroupsFifth Wheel Group Interested in fifth wheels? You've come to the right spot.Feb 18, 202519,006 PostsTravel Trailer Group Prefer to camp in a travel trailer? You're not alone.Feb 18, 202544,025 Posts