I have been doing some searching to no avail, but I know the answer is out there. When I comes to converting your electric drum to disk brakes there are a few kits to choose from. But why $500 for a disk hub, backing plates and calipers? Example; ...
I have a 2006 F37SP Sierra Sport TH. I am going to be replacing the equalizers and shackles. My dilemma is how to safely jack up one side and support the trailer in order to remove both wheels and do the work.My first thought is to hook it up to th...
I have a 2006 Sierra Sport toyhauler 5er where the ladder to access the roof is on the front driver's side of the trailer. I found a soft spot just to the left of the ladder where the nose cap meets the roof line. It is about 10"-12" in diameter.Th...
This is more of a question on how it was done. I did a search and couldn't find anything similar that was done. Here is a video of what this guy did for his screen door.Screen door modMy question is how did he attach the magnete to the door and wha...
I have a 2006 Sierra Sport 38' toyhauler. The batteries are crammed into this little itty bitty space making it hard to check and service them plus there is only enough room for two of them. I want to move them into the storage compartment in the e...
Ok first off I was not asking for a tongue lashing. I took all information and made my own decision. Secondly it was posted by a member it was done on his RV. The entire trailer was supported on four Jack stands not just the front landing gear.
I wanted to update this. My front landing gear motor is not powerful enough to lift the trailer with the jack stands at the rear of the rear axle. I had to eventually use my 3 ton jack to lift it the rest of the way. On each side of course.
CA Traveler wrote:The OP needs to add a ATS or manual DPDT switch to the inverter output and the plug circuit. Yes! For sure! I am surprised you haven't fried your inverter.Maybe this post will help. https://www.rv.net/forum/index.cfm/fuseaction/thre...
If you can weld I would say install a 2x2 square tubing between the hanger brackets. The X-Factor is good if you do not have access to a welder or cannot weld.
CarnationSailor wrote:Calkidd wrote:SDcampowneroperator wrote:with Auto sliders your truck and rig must be straight aligned to connect/ disconnect. Too limiting in my opinion, you could not pay me to have one.Simply not true.Well, yes, it is true.I ...
