All ActivityMost RecentMost LikesSolutionsRe: Converter/charger trips breakerThis is the answer I got from Buss Fuses. "It doesn't matter which way the breaker is wired current will flow either way. For consistence I tell all our customers BAT goes to Line/Power and AUX to Load." I thank everyone for all the input.Re: Converter/charger trips breakerThanks. I checked the wire and it's all #4 with about a one foot run each. I appreciate the input.Re: Converter/charger trips breakerWow, it sounds like you really know what you're talking about and I really appreciate you taking the time to explain it. Thanks so much. I will connect Batt to Battery and Converter to Aux.Re: Converter/charger trips breakerI think your right. I'm just going to hook it up and see how it works.Re: Converter/charger trips breakerThanks for the reply, it seems that way to me. It's a 1999 HitchHiker that used to have a 45 watt converter / charger. That went bad, so we replaced it with a higher amp model, but the RV mechanic didn't change the circuit breaker. One cold night with the heater running drained the battery, so I hooked up the generator and the converter put out in boost mode and tripped the circuit breaker. I guess I will go with my gut until I find out more info.Converter/charger trips breakerI have an Inteli-Power 9160A converter/charger that tripped the 45AMP circuit breaker when it went into boost mode. I contacted the manufacturer and they said I should install a 60 amp circuit breaker. I bought a HI-AMP BUSS 60 amp circuit breaker. One terminal is labeled BATT the other is labeled AUX. I'm not sure if I should connect the Charger to the terminal marked AUX and the terminal marked BATT to the battery bank, since the battery is the one drawing the high current. This circuit breaker is also used for trolling motors and the trolling motor is connected to the AUX terminal since the trolling motor is drawing the current. My situation is the batteries will draw the current. Thanks.