Fixing 'er Up '03 Fleetwood Bounder
1st Project: Water Heater Upgrade Old water heater: GC10A-3E to GE16EXT. They are both 10 Gallons, ignition controlled, and powered by LP Gas & Electric. I repaired damaged metal around the water ...
Forum Discussion
I'm confused on the rat nest...???
Haha, the water heater door hides that messy job. ;)
There is a crack in the fender which I used caulking to seal it. I should have used clear but on hand all I had was white. I haven't done it yet but I plan to cut and peel the excess caulking off. Once I do that I will take pics and post them. :)
Take Note: the new 10 gallon water heater acts like a 16 gallon and has a shorter time frame of heating the water. This model has an additional wire to control the electric side of the heater. I had to route a new wire which activates a relay to control the electric side of the heater unlike the old model which used a regular 120 VAC switch.
Haha, the water heater door hides that messy job. ;)
There is a crack in the fender which I used caulking to seal it. I should have used clear but on hand all I had was white. I haven't done it yet but I plan to cut and peel the excess caulking off. Once I do that I will take pics and post them. :)
Take Note: the new 10 gallon water heater acts like a 16 gallon and has a shorter time frame of heating the water. This model has an additional wire to control the electric side of the heater. I had to route a new wire which activates a relay to control the electric side of the heater unlike the old model which used a regular 120 VAC switch.
