How to convert to LED lighting
Hi, I think some of you will be interested in how I converted my RV lights to LED. I initially tried 12 volt LED bulbs about 5 years go, and they were not satisfactory: they were expensive, didn'...
Forum Discussion
OK so here is my LED story. First I tried a few different types of cobb lights but found that they didn't do as good of a job as the flat panel(shine downward type). I am very happy with my 24-5050 panels for over my sink and table. I am also very happy with my 12-5050 disks wedge base panels for everywhere else. I found that the 24-5050 puts out a bit more light than stock and the 12-5050 put out a bit less. I really like the disk style because you attach using the wedge and not tape or other (leaving lots of room for air movement).
So the second part of my story starts now. I searched LED2010 site and found that they now offer the disk type (12-5050) in a regulated 11-30v for a bit more $$ and some flat panel 36-1210 regulated 11-26v (10 for $39.99).
So my question is::: I have heard people say that the regulated ones will produce interference. Is this on radio? TV? All electronics? A wise tale? or just special electronics like ham radio and such?
Thanks in advance. Don.
So the second part of my story starts now. I searched LED2010 site and found that they now offer the disk type (12-5050) in a regulated 11-30v for a bit more $$ and some flat panel 36-1210 regulated 11-26v (10 for $39.99).
So my question is::: I have heard people say that the regulated ones will produce interference. Is this on radio? TV? All electronics? A wise tale? or just special electronics like ham radio and such?
Thanks in advance. Don.
