My latest Mod

jimgoss wrote:
Was it a pain to run the wiring? I would love to install a step light like that too but am leary about drilling thru the underbelly.

actually it was very easy to run the wire,, the converter is in the cabinet below where I put the switch, the main harness ran thru the floor right there, took a couple of the screws that hold the underbelly on and was able to feed the wire right thru that, I did put a small piece of hose around the wire where it passed under the frame. I wanted to wire mine into the same switch that turns on the reg outside light, but would have been a real pain to do that.

Was it a pain to run the wiring? I would love to install a step light like that too but am leary about drilling thru the underbelly.

Yes, we have one too. It came with it. Comes on with the porch light. It is very nice to have but I feel too bright. I will be replacing with a smaller LED. Your install is very nice.

Nice job!

The lit switch is a great idea.

.

I did similar mod to my RV/TT.

IMO, this should be minimum factory build.

You do great work.

Nice Mods!

Good idea. Nice clean job, it looks like a factory installation.

My converter is just inside the door where I put the light,, there was already a hole in the floor for the other wires to go thru,, I just took a few of the screws out for the underbelly and put the wire out, I did drill and tap holes in the frame for the light, I think they were 1/4 20 x 3/4 bolts I used,,

Mine came with the light mounted and a switch inside. I do like the light.

Good idea, I'll have to look at mine and see if I can do the same.