Remove bunkbeds to make work space?
I am going to be living full time this summer in my 35' TT and working online from there. There is a work surface at the rear of the trailer but it is very small and I am thinking of removing the two ...
Forum Discussion
SoundGuy wrote:
... the problem I ran into though was that the framing for those beds had been secured to the inside wall by running screws through from the outside before the trailer's outer wall had been installed. This may be a common construction technique but of course I didn't realize it at the time so when I finally did manage to pull that bed framing free it left some pretty large holes in the trailer's interior sidewall where the screw heads pulled through the interior wall paneling.
westend wrote:
Instead of pulling the fasteners through the framing, you could have cut them with a reciprocating saw.
True, but as I already said - "... but of course I didn't realize it at the time". Even if I had I don't own a reciprocating saw anyway ... didn't then back in 2007 and still don't. :W
