Replaced roof molding screws
I replaced all the screws in the molding holding down the rubber roof with stainless steel screws dipped in 3M5200. That is a lot of screws! Do I need to do anything else? Run a bead of sea...
Forum Discussion
Hmmm . Yours must be different from the way mine is made. On mine the screws are near the top of the strip and behind a vinyl trim that keeps water out so it really wouldn't hurt anything if the drip rail were to have debris in it as all that would happen is the water would overflow the edge and run down the side of the unit instead of going to whatever end was lowest. That sounds like a bad design, but it is what it is.:h
