Replaced roof molding screws
I replaced all the screws in the molding holding down the rubber roof with stainless steel screws dipped in 3M5200. That is a lot of screws! Do I need to do anything else? Run a bead of sea...
Forum Discussion
Larry, would RainKap be helpful for my application?
http://www.rvaccessorypart.com/page/page/3352092.htm
It would bypass the Jayco Eagle gutter system that has a gutter and a small tube with a slit in it underneath the gutter. I guess the small tube is to collect water that goes over the gutter. My awning is underneath the molding, but I'm not sure there is enough space to mount the RainKap. I guess I could cut it down.
This would address the issue presented by Gjac. I do'k know of any other way to seal the molding unless I covered the entire thing in Eternabond.
http://www.rvaccessorypart.com/page/page/3352092.htm
It would bypass the Jayco Eagle gutter system that has a gutter and a small tube with a slit in it underneath the gutter. I guess the small tube is to collect water that goes over the gutter. My awning is underneath the molding, but I'm not sure there is enough space to mount the RainKap. I guess I could cut it down.
This would address the issue presented by Gjac. I do'k know of any other way to seal the molding unless I covered the entire thing in Eternabond.
