where to put volt/amp meter in circuit
looking to install meter near WFCO. Currently, it is wired with RED & White into meter > WFCO and only reads AMPS when plugged into shore. Can someone please look at circuit diagram and tell me whic...
Forum Discussion
Is there something you are suppose do when you want to monitor DISCHARGING or CHARGING modes.
Perhaps you have to also move the battery load somehow. The battery is connected to all your trailer loads via the 12VDC Distribution panel. The battery should connect to this panel normally at the same point the converter connects to 12VDC Distribution panel. Perhaps the REVERSE POLARITY FUSES BLEW ON YOU. They are the two large 15AMP fuses off to them self on the 12VDC board.
One good check is see if your 12VDC ceiling lights works OK when you are NOT on shore power. We may have interrupted the path from the battery positive lead to the 12VDC Distribution Panel somehow by going thru the new meter. ???
Roy Ken
Perhaps you have to also move the battery load somehow. The battery is connected to all your trailer loads via the 12VDC Distribution panel. The battery should connect to this panel normally at the same point the converter connects to 12VDC Distribution panel. Perhaps the REVERSE POLARITY FUSES BLEW ON YOU. They are the two large 15AMP fuses off to them self on the 12VDC board.
One good check is see if your 12VDC ceiling lights works OK when you are NOT on shore power. We may have interrupted the path from the battery positive lead to the 12VDC Distribution Panel somehow by going thru the new meter. ???
Roy Ken
