Forum Discussion

Glenalt's avatar
Glenalt
Explorer
May 25, 2015

Bedroom TV Not Working On Cable

I have been using the antenna but am in a place that has cable but cannot get the bedroom TV to work. I am not using the booster. Have done a channel scan but can't get any to show up.

The LR TV works great.

I can't remember what they said to do about the loop next to the booster connector in the bedroom. Anyone have any ideas?

Thanks, Glen

5 Replies

  • Glenalt's avatar
    Glenalt
    Explorer
    May 26, 2015
    Thanks everyone. I had the TV hooked up to a analog converter box and I disconnected it and went directly to the connector at the amplifier switch. It worked great.
  • jffnkrn's avatar
    jffnkrn
    Explorer
    May 25, 2015
    my other trailer had two connections outside, one said satellite and one cable. it just so happened that the satellite one was hooked up to the bedroom, double check those and see if that helps.
  • Our_Place's avatar
    Our_Place
    Explorer
    May 25, 2015
    I just went through this same problem, make sure you go into the TV setup and switch it from "air" to "cable" then do another channel scan. Leave the loop connected and make sure the antenna booster is turned off.
  • aruba5er's avatar
    aruba5er
    Explorer
    May 25, 2015
    mine didn't work either. wire (coax) was not crimped into connector at the boaster where they all come together by the amplifer with the boost switch.
    Take the outlet plates off and see if everything is connected

About Fifth Wheel Group

19,027 PostsLatest Activity: Jun 19, 2019