Bedroom TV cable needs replaced.

It's for my dish satellite.

I ran HDMI's through the A/C ducts.

you can use butt connectors that screw right into the end of the old cable and in the end of the new cable then pull like mad to route the new cable

Is this for Cable TV or OTA broadcast TV? Is that 1 TV the only one effected.

this should answer the question about wiring wiring diagrams?

You could do this with out a diagram,with anew 25' cable sans one end, open up the panel where it comes into the room, and where it enters, the open that end. Try tugging real hard,,,but don't pull it out.
Tight tape the new onto the old after you cut the old connector off, and start pulling .. you may want to get some wire pulling goo from an electrician which helps the slid of the wire.


I doubt if it stapled any where in the unit.

Good luck.

the tv cables usually run through the walls and ceiling not underneath but anything is possible depends on the rv and any modifications that may have been done. your unlikely to find a wiring a diagram for most rv's.

2011 Alpine 5th Wheel 3555RL

It would help if you told us what your RV is.