Front electric jack motor
I have an electric motor that extends my front stabilizers, there is a hand crank to over ride if motor fails. Is there any preventive maintance to do to keep them in good working condition as they ar...
Forum Discussion
Inside the front storage where the jacks are mounted on to top of each end is a plastic cap where the gears are. Make sure they are full of grease( wheel bearing grease is fine). Plus I drilled a small hole in the side of the square tubing the acme thread shaft is housed. Just big enough to get my squirt oil can in. I raised the front up till the inner square tubing is out of the way and the acme shaft is visible. Then I take synthetic gear oil and put the can against the shaft and put about 20 squirts one each shaft. After a while it will leak down and on the inner square tubing outside. I wipe the excess off. That is the only way I have found to lube the shaft. Since I cannot get the trailer high enough to work from the bottom up outside.
